Showers and tub surrounds
Waterproofed, sloped to drain, and tiled floor to ceiling.
Tile installation in Jacksonville, FL
Showers, floors, backsplashes, and walls — waterproofed where it counts and set with straight, clean grout lines. Licensed and insured. Call (904) 604-7606.
Scope
What wehandle.
One crew from demo to final trim. Here is what this work covers.
Floors
Porcelain, ceramic, and large-format, set flat with tight joints.
Backsplashes
Kitchen and bath, mosaic or straight-set, cut clean around outlets.
Feature and accent walls
Hand-laid patterns and stone-look tile.
Waterproofing
Membrane on every wet wall and shower floor before any tile.
Materials
Built to astandard.
The part you do not see is what holds the finish together. We do not cut it.
Waterproofing
Membrane on every wet wall and shower floor before any tile, because in Florida a shower that skips it leaks.
Dry-lay
The tile laid out before adhesive so the pattern and the cuts land where they should.
Setting
Tile set to a level line, mitred outside corners on stone, clean cuts around fixtures.
Tile types
Porcelain, ceramic, mosaic, and natural stone, matched to the job.
Slope and drain
Shower floors sloped to drain so water goes where it should.
Grout and seal
Grout color confirmed against your sample, lines kept straight, sealed where it makes sense.
Process
How the work runs.
Four steps, start to finish. You know what is happening at each one.
-
Free consultation
Walk the space with Juan, get an honest estimate, no pressure. On site.
-
Design and scope
Nail down materials, timeline, and the exact scope in writing before anything starts.
-
Build
One crew, licensed and insured, on site until it is done right. Floors protected, cleaned down daily.
-
Walk-through and warranty
A full walk-through before you pay the balance, and we stand behind the work.
Tile installation in Jacksonville, FL — showers, floors, backsplashes, and walls, waterproofed where it counts and set with straight, clean grout lines. HammerHead does the part behind the tile right, because in Florida a shower that skips waterproofing leaks. Licensed and insured. Call (904) 604-7606 or get an estimate.
Juan Gomez has set tile and remodeled on the First Coast since 2016. Straight lines and dry showers come from the prep — the layout and the waterproofing you don’t see once the tile’s on.
Featured work
Recent work
Tile project
Tile project
FAQs
Common questions.
What clients ask about scope, timeline, and how the work runs.
What do you tile?
Showers and tub surrounds, floors, kitchen and bath backsplashes, feature walls, and fireplace facing. Porcelain, ceramic, mosaic, and natural stone tile. If it takes tile, we set it.
How do you waterproof a shower?
With a proper membrane on every wet wall and the shower floor before a single tile goes on, and a pan sloped to drain. In Florida, moisture wins if you skip this. It's the step that keeps a shower from leaking behind the wall — we never cut it.
Can you fix a leaking or failing tile shower?
Usually, yes. When a shower leaks, it's almost always because the waterproofing was skipped or done wrong. We tear out the failed work, show you what we find, waterproof it correctly, and re-tile. Covering it back up isn't a fix.
How do you keep the tile lines straight?
We dry-lay the tile first so you can see the layout before anything's set, plan the cuts so they fall where they're least visible, and set to a level line. On outside corners we mitre the tile instead of hiding the edge under a bead of caulk.
What about the grout?
We confirm the grout color against a sample before we bag it, keep the lines consistent, and seal where it makes sense. Straight, even grout lines are most of what makes a tile job look right or look rushed.
Are you licensed and insured?
Yes. HammerHead is licensed in Florida and carries insurance. We'll confirm it before we start.
Areas · Where we work
Serving the First Coast
Licensed and insured across Duval and St. Johns counties. Call (904) 604-7606 for coverage in your area.
